1 Reply by manuel

(7 replies, posted in Technical)

Hi,

i got my scale successfully working via wifi and now i would like to have it send the data via the LoRa chip. The university has set up a LoRa network in town and is using it to get in data from DIY weather stations. They are happy about alternative uses so I wanted to use their network to get my scale-data in.The next gateway is in line of sight about 800m away.
Therefore I was wondering if all the steps described above by phisch92 are necessary to get the data in via LoRa? I am no programmer, come from the beekeeping side of things and therefore have no knowledge about the network/programming details. The scale shows the deveui when requested in config mode. I assumed it will automatically connect and send in the data once in range of the lora network and display it in the graph on the monitoring page (as it does for wifi connection). Or are there additional steps necessary to make it work?

Thanks a lot for the help! smile
Cheers from Norway

manuel

Go to forum: Technical

2 Topic by manuel

(2 replies, posted in Technical)

Hi,
I have assembled my scale but I cannot find any information on the placement of the motor endstop sensor. I followed the assembly manual and checked the according videos but do not seem to find it. In video 20 the sensor cable is connected but the sensor itself is already placed. Maybe its mentioned, but I only watch the actions and do not understand the french comments smile
It would be nice if someone could help out or send some images.
thanks a lot!
manuel

Go to forum: Technical